HOME USED PARTS TOUR TECH AND SPECS CONTACT US


HAYABUSA CS1300STN CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud location before removing. There may be several different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use APE stud installation tool #08-151 or two 10x1.25mm nuts on the short end thread. Dip long thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

5. Using APE CHN10125.10 head nuts, torque to 65 lbs..

HOME

CSZX14 CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud location before removing. There may be several different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use two 7/16 nuts on the short end thread. Dip long thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

5. Using APE head nuts, torque to 55 lbs..

HOME

CS1200K CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud location before removing. There may be several different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use two 7/16 nuts on the short end thread. Dip long thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

5. Using APE head nuts, torque to 70 lbs..

HOME

CS1000GSX CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud location before removing. There may be several different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use APE stud installation tool #08-151 or two 10x1.25mm nuts on the short end thread. Dip long thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

5. Using APE CHN10125.10 head nuts, torque to 60 lbs..

HOME

CSZX10 CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud location before removing. There may be several different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use APE stud installation tool #08-151 or two 10x1.25mm nuts on the short end thread. Dip long thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

5. Using APE CHN10125.10 head nuts, torque to 60 lbs..

HOME