HOME USED PARTS TOUR TECH AND SPECS CONTACT US

 

CS900H CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Short threaded end must be installed in the case.

2. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

3. Use APE stud installation tool #08-151 or two 10x1.25mm nuts on the long end thread. Dip short thread in oil and install in the case. Torque to 12-15 ft. lbs. maximum.

4. Install head, and following manufacturer's torque pattern, torque nuts to 34-38 ft. lbs.


CS750H CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud length location before removing. There are two different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use APE stud installation tool #08-151 or two 8x1.25mm nuts on the noted location, bottoming out, then using a torque wrench torque to 8 ft. lbs. maximum.

4. Install head, and following manufacturer's torque pattern, torque nuts to 20-22 ft. lbs.


CS500H CYLINDER STUD INSTALLATION INSTRUCTIONS

1. Long threaded end must be installed in the case.

2. Note stock stud length location before removing. There are two different stud lengths.

3. After removal of stock studs (removal tool #SP-100 available from APE) thoroughly clean holes with solvent and blow out.

4. Use APE stud installation tool #08-151 or two 8x1.25mm nuts on the noted location, bottoming out, then using a torque wrench torque to 8 ft. lbs. maximum.

4. Install head, and following manufacturer's torque pattern, torque nuts to 20-22 ft. lbs.