INSTALLATION INSTRUCTIONS PRESS ON CAM SPROCKET ADAPTERS KAWASAKI ZX7

BEFORE REMOVING STOCK SPROCKETS FROM THE CAMS...note that the stock sprocket has the markings; IN and EX with lines. On the intake cam, scribe a line or make a center punch mark in line with the line under "IN". On the exhaust cam, mark it in line with the line under "EX". Now carefully remove the sprockets.

Install the APE sprockets on the adapters so that the bolt is centered in the slot and snug bolts. On the APE sprockets, the single dot represents the line under IN. Position the adapter on the intake so that the dot lines up with the mark you made on the cam. Remove sprocket and install adapter.

Repeat for the exhaust cam with the double dots representing the line under "EX".

Clean all oil from the adapter and use Locktite. Be sure not to get Locktite in the bearing. Press the adaptor on straight. If it is not installed straight, the sprocket will wobble.

After cams are degreed in, lock bolts to 17-19 ft. lbs. of touque. DO NOT OVER TIGHTEN AS DAMAGE TO THE ADAPTER CAN OCCUR.