PRESS ON CAM SPROCKET ADAPTERS
Before removing the stock cam sprocket, scribe a line on the end of the cam that lines up with the number 1 on the stock sprocket. Now remove the stock sprocket. Assemble the APE sprocket on the APE adapter so that the sprocket mounting bolts are approximately in the center of the oval slots. Now index the adapter so that the line you made on the cam lines up with the single dot on the APE sprocket. Press adapter on to cam in this position. Repeat for exhaust cam.
Clean all oil from adapter and use Loctite. Be sure not to get Loctite in the bearing. Press the adapter on straight. If it is not installed straight the sprocket will wobble.
After cams are degreed, lock bolts to 17-19 ft. lbs. of torque. DO NOT OVER-TIGHTEN AS DAMAGE TO THE ADAPTER CAN OCCUR.