MBS1000K INSTALLATION INSTRUCTIONS
1. Clean out holes...If
necessary run an 8mmx1.25 tap into the hole. DO NOT TAP HOLE
ANY DEEPER!!!!
2. Set empty cases together
to determine where studs go.
3. Using two wrenches,
lock two 8x1.25mm nuts on one thread (do not use nuts suppled
with. Use locktite on case thread and install. Bottom out and
torque 8 ft. lbs. max.
4. Upon assembly, use locktite
and torque nuts to 20-22 ft lbs.
HOME
|